Mars Pro extras

As good as the Elegoo Mars Pro is, there will always be ways to adapt things to suit your needs better. After all that’s why we have 3D printers and design software isn’t it. Luckily to save me the design time other people had already had the ideas so it was just a case of printing them.

A handle to make lifting the cover easier and a one handed job. Also stops me gets resin on the cover itself.

A cover for the vat between prints and to keep it clean.

The STL’s for these are:

Handle - https://www.thingiverse.com/thing:3839160

VAT cover - when i find it I’ll post it

I printed them both on my CR-10s. Obviously being a bit tight on the handle as I printed the first half in what was left on an old spool of filament and then switched to the red.